Disc mower
72
GMD240-280-310
Maintenance and storage
KN204AGB H
Checking cutterbar oil level
- Regularly check the cutterbar oil level:
- Place cutter bar in vertical position.
- Remove filler plug (1) and its washer.
- Check the oil level: The oil must reach the lower edge
of the filling hole (1).
- Top up if necessary.
- Clean and reinstall filler plug (1) and its
washer. Replace if necessary.
Before draining oil, operate the machine for a
few minutes so that the oil warms up.
Wait one hour for the oil to accumulate in the
lower part of the cutter bar.
If it is found that the transmission case is very hot
to touch by hand, there is no cause of alarm
provided:
• Lubrication recommendations have been
respected.
• Discs can be rotated freely by hand when
the machine is hot.
Before carrying out any maintenance or
repairs on the machine, switch off the tractor
engine, remove ignition key, wait until all
moving parts have come to a standstill and
apply park brake.
To Next Page
Loading...
