What to do if the conveyor belt is clogging on KUHN FC703 RA Farm Equipment?
If the conveyor belt is clogging on your KUHN Farm Equipment, first, readjust the conveyor belt speed using the control box. If the issue persists, check the conveyor belt tension and adjust it if necessary. Also, ensure there is sufficient oil in the hydraulic tank by checking the oil level in the reservoir and topping it up if needed.
How to fix uneven stubble with KUHN FC703 RA?
If you notice uneven stubble with your KUHN Farm Equipment, it might be due to dull or broken knives; in this case, replace the knives. Ensure that the knives are installed correctly, with the arrow on the knife's upper face pointing in the disc's direction of rotation. Also, check the PTO speed and increase it to 1000 min-1 if it's too low.
How to fix badly shaped windrows with KUHN Farm Equipment?
If your KUHN Farm Equipment is producing badly shaped windrows, it could be due to belts slipping, so retension them. Also, ensure that the PTO speed is at the correct level by increasing it to 1000 min-1 if it's too low.
What to do if the mowing units do not fold on KUHN Farm Equipment?
If your KUHN Farm Equipment mowing units do not fold, first place the machine in the headland turn position, as the machine can only be put in transport position if the machine is in working position. Then, check that the right mowing unit transport hook is fully engaged. Finally, ensure that the cutterbar lock is unlocked.
How to improve ground contour adaptation on KUHN FC703 RA?
If your KUHN Farm Equipment experiences bad ground contour adaptation, adjust the main frame height with regards to the ground. Reduce ground speed and accumulator pressure. If possible, lock the suspended front axle.
What causes soil build up in front of the cutterbar on KUHN Farm Equipment?
If soil builds up in front of the cutterbar of your KUHN Farm Equipment, it may be due to too much cutterbar down pressure. Increase the accumulator pressure to resolve this. If you are working in very wet conditions, adjust the main frame height with regards to the ground.
Why does KUHN FC703 RA Farm Equipment require too much pull power?
If your KUHN Farm Equipment requires too much pull power, adjust the mowing unit ground pressure.
What to do if the conditioning rotor is obstructed on KUHN FC703 RA Farm Equipment?
If the conditioning rotor of your KUHN Farm Equipment is obstructed, check that the rotor drive belts are correctly tensioned. Also, increase the PTO speed to 1000 min-1 if it's too low.
What to do if the control box doesn't come on for KUHN Farm Equipment?
If the control box of your KUHN Farm Equipment does not come on and controls no functions, the thermal fuse may be triggered. Find the origin of the short circuit.
General| Brand | KUHN |
|---|---|
| Model | FC703 RA |
| Category | Farm Equipment |
| Language | English |
To Next Page
