KUHN GA4521GTH - User Manual

Questions and Answers

C
clarkcatherineAug 14, 2025
What to do if the torque limiter disengages frequently on KUHN Farm Equipment?
- K
  kimberly22Aug 14, 2025
  If the torque limiter on your KUHN Farm Equipment frequently disengages, it could be due to a high load on the tine arms. Try adjusting the wheel height. Also, consider reducing your ground speed.
M
Melissa SmithAug 17, 2025
Why is KUHN GA4521GTH picking up crop at the rear of the rotor?
- M
  Mrs. Cathy Ball DDSAug 17, 2025
  If your KUHN Farm Equipment is picking up crop at the rear of the rotor, it might be because the swaths are too compact between the tines and swath screen. Increase the swath screen distance to resolve this. Additionally, check if there are earth clods on the tines and adjust the wheel height accordingly. You may also need to reduce the PTO speed if the rotor speed is too high.
J
jacksonjamieAug 20, 2025
How to stop unusual rotor vibrations in KUHN GA4521GTH Farm Equipment?
- L
  Lindsey DavisAug 20, 2025
  If you're experiencing unusual rotor vibrations with your KUHN Farm Equipment, the rotor speed may be too high. Check the PTO speed and ensure it does not exceed 540 min-1.
L
Lynn ChurchAug 25, 2025
How to fix poor raking over the whole rotor width on KUHN Farm Equipment?
- E
  emily25Aug 25, 2025
  If you're experiencing poor raking over the entire rotor width with your KUHN Farm Equipment, it could be that the tines are too far from the ground. Adjust the wheel height to correct this.
M
Malik HansenAug 27, 2025
What to do if KUHN GA4521GTH Farm Equipment ejects crop at the front of the swath screen?
- C
  Christopher DiazAug 27, 2025
  If your KUHN Farm Equipment is ejecting crop at the front of the swath screen, it could be due to an incorrect swath screen position, particularly if it's too far at the rear. Move the swath screen forwards. Also, try to reduce the PTO speed.
K
Kathryn HerreraAug 30, 2025
How to fix poor raking on one side of the rotor on KUHN GA4521GTH Farm Equipment?
- M
  murphyjosephAug 30, 2025
  If you notice poor raking on one side of the rotor of your KUHN Farm Equipment, the rotor might be tilted towards the opposite side. To fix this, adjust the wheel height to achieve the same tine-to-soil distance on both sides of the machine.
S
Shelby HughesSep 3, 2025
What causes poor raking on the two sides with KUHN GA4521GTH?
- B
  Blake SinghSep 3, 2025
  If your KUHN Farm Equipment is showing poor raking on both sides, the rotor might be tilted forward. Adjust the drawbar cylinder to resolve this issue.
E
Erin EvansSep 6, 2025
How to resolve poor raking in the middle with KUHN GA4521GTH?
- J
  Jennifer TerrySep 6, 2025
  If you're experiencing poor raking in the middle with your KUHN Farm Equipment, the rotor might be tilted rearwards. Try shortening the top link to correct this.
T
tjohnsonSep 10, 2025
Why is KUHN Farm Equipment ejecting crop underneath the swath screen?
- T
  Tamara SchneiderSep 10, 2025
  If your KUHN Farm Equipment is ejecting crop underneath the swath screen, it's likely that the swath screen position is incorrect, being too far away from the ground. Adjust the swath screen downwards to fix this.