What to do if soil builds up in front of the KUHN GMD700GII cutterbar?
If soil builds up in front of the cutterbar of your KUHN Lawn Mower, it could be due to too much cutterbar down pressure. Try adjusting the compensating spring tension. Also, if working conditions are very wet, adjust the main frame height with regards to the ground and consider fitting raised skid shoes.
Why is the KUHN GMD700GII leaving uneven stubble?
If the stubble is uneven when using your KUHN Lawn Mower, several factors could be at play. The knives might be dull or broken, requiring replacement. Ensure the knives are correctly installed, with the arrow on the upper face pointing in the disc's direction of rotation. Insufficient disk speed may be the problem, so check the belt tension. Also, verify that the PTO speed is at 540 min-1. Lastly, the cutter bar pitch angle might be too high, so reduce it.
What to do if the KUHN Lawn Mower safety breakback releases too often?
If your KUHN Lawn Mower's safety breakback releases too frequently, the spring washer compression might not be sufficient. Increase the spring washer compression to resolve this issue.
How to fix stubble that is too long with the KUHN GMD700GII Lawn Mower?
If the stubble is too long when using the KUHN Lawn Mower, it could be due to an incorrect cutter bar pitch angle. Modify the pitch angle using the top link to correct this. It may also be that the machine is too light. In this case, adjust the compensating spring tension and check the frame position.
Why does my KUHN GMD700GII Lawn Mower have bad ground contour adaptation?
If your KUHN Lawn Mower has bad ground contour adaptation, the main frame setting might be incorrect; adjust the main frame height with regards to the ground. Excessive ground speed can also cause this, so reduce your speed. Another potential issue is a blocked hydraulic cylinder; set the hydraulic valve in the floating position. Incorrect compensating spring adjustment may also be the reason, so adjust the compensating spring tension. Finally, check the condition of the cutter bar pivot bushes and replace if necessary, as they may be worn or seized.
How to stop interference between tractor and front guard on KUHN GMD700GII?
If there is interference between the tractor and the front guard of your KUHN Lawn Mower, the cam adjustment may be incorrect. Adjust the machine pivot moment to resolve this.
Shows the machine from the front.
Shows the machine from the rear.
Details for identifying the machine.
Lists available additional parts for the machine.
Explains warning symbols used in the manual.
General safety guidelines for machine operation.
Identifies and explains safety labels on the machine.
Safety requirements for operating on public roads.
Defines terms and lists machine components.
Lists machine dimensions and performance data.
Specifies noise emission data for the machine.
Explains the machine's control elements.
Provides steps for attaching and detaching the machine.
Details on preparing the machine for transport.
Ensures compliance with highway code for road transport.
Steps for deploying the machine into mowing position.
How to set up the machine for optimal cutting.
Guidelines for operating the machine during work.
Optional skid shoes to improve ground clearance.
Optional disc to affect crop swath width.
Optional kit to adjust swath width.
Optional shield to reduce swath width.
Optional deflector for dense crops.
Optional deflector for dense crops with high cone discs.
Optional lighting and signalling for road safety.
Optional lateral signalling for road compliance.
Optional connector for specific tractor hitches.
Optional pins to adjust machine offset.
Overview of the maintenance schedule.
Details on greasing points and schedule.
General procedures for machine maintenance.
Instructions on how to store the machine.
General| Brand | KUHN |
|---|---|
| Model | GMD700GII |
| Category | Lawn Mower |
| Language | English |
To Next Page
