Why is my KUHN HR 5002 DR using too much power?
Excessive power consumption in your KUHN Farm Equipment can stem from several factors. The working depth might be too deep, so adjust the machine to a higher setting using the rollers. Ensure the depth isn't set deeper than necessary. High rotor speed could also be the culprit; reduce it at the gearbox. Additionally, reduce forward speed, and adjust the leveling bars to a higher setting.
What to do if the KUHN HR 5002 DR tilth produced is too coarse?
If your KUHN Farm Equipment is producing a tilth that is too coarse, there are a few potential reasons. Check for and eliminate any build-up of long plant residues around the blades. Reduce forward speed. You might also need to increase the rotor speed at the gearbox. If there are no leveling bars, consider installing the leveling bars preferably towards the rear.
What to do if the KUHN Farm Equipment tilth produced is too fine?
If the tilth produced by your KUHN Farm Equipment is too fine, it could be due to several reasons. Try reducing the rotor speed at the gearbox. Increasing the forward speed may also help. Check the rear leveling bars; if they are too low, raise or remove them. Also, fit the leveling bars to the front.
Why is the KUHN HR 5002 DR Farm Equipment drive noisy during work?
A noisy drive during operation of your KUHN Farm Equipment can be attributed to a couple of things. If the machine is tilted, lengthen or shorten the top link to set the machine horizontally during work, ensuring the tractor PTO shaft end and machine input shaft are parallel. Also, make sure that you tighten the tractor's anti-sway stabilizers if the machine is insufficiently stabilized and moves from side to side.
How to fix ridging at the side of the KUHN Farm Equipment?
Ridging on the side of your KUHN Farm Equipment is likely due to the anti-ridging plate being incorrectly positioned on the side deflectors. To correct this, position each anti-ridging plate closer to the ground and to the corresponding roller.
Why is my KUHN HR 5002 DR Farm Equipment drive noisy when lifting?
A noisy drive when lifting your KUHN Farm Equipment can be caused by a badly positioned or adjusted top link of the 3-point hitch; position the top link parallel to the lower lift arms. Also, reduce lifting height if it's excessive.
What causes plugging from ground build up in front of the packer rollers on KUHN HR 5002 DR Farm Equipment?
Plugging in front of the packer rollers on your KUHN Farm Equipment can occur for a few reasons. If you're working with sandy soil, try mounting the leveling bars to the rear. Slightly lengthen the top link. Also, reduce forward speed. Consider using maxipacker rollers (for HR 6002 DR / 6002 DR - S).
How to solve erratic packer rollers function in KUHN HR 5002 DR Farm Equipment?
Erratic packer roller function in your KUHN Farm Equipment can be due to several issues: * Worn or incorrectly adjusted scraper plates, position each scraper plate closely to the corresponding roller. * Scrapers jammed by trash, clean the scrapers by pivoting them to the rear. * Scraper bars incorrectly positioned, make sure that the scraper bars are in its furthest forward position. Plates must only be slid forward one at a time.
What causes excessive blade wear on KUHN HR 5002 DR Farm Equipment?
Excessive blade wear on your KUHN Farm Equipment can be attributed to high rotor speed. Reduce the rotor speed and fit the rear leveling bars.
How to prevent maxicrumbler roller clogging in KUHN HR 5002 DR Farm Equipment?
If your KUHN Farm Equipment's maxicrumbler roller is clogging, especially in humid conditions, consider using a packer roller instead.
General| Brand | KUHN |
|---|---|
| Model | HR 5002 DR |
| Category | Farm Equipment |
| Language | English |
To Next Page
