Why does my KUHN HRB202 have excessive power requirement?
Excessive power requirement in KUHN Farm Equipment can be attributed to several factors. The working depth might be too deep, so reduce it using the roller. The rotor speed could be too high; reduce it by changing gearwheels in the gearbox. Excessive ground speed can also be a cause, so reduce it. Finally, the rear levelling bar might be incorrectly set; raise or remove it.
What to do if KUHN HRB202 tilth produced is too coarse?
If the tilth produced by your KUHN Farm Equipment is too coarse, consider these points. First, eliminate any plant residues that may be building up around the blades. Second, reduce ground speed. Third, increase rotor speed by changing gearwheels in the gearbox. Lastly, install the levelling bar, preferably to the rear.
How to fix KUHN Farm Equipment when tilth produced is too fine?
If your KUHN Farm Equipment is producing tilth that is too fine, consider the following: reduce the rotor speed by changing gearwheels in the gearbox. Also, increase the forward speed. Finally, raise or remove the rear levelling bar.
Why is my KUHN HRB202 drive noisy during work?
A noisy drive during work with KUHN Farm Equipment can stem from a couple of issues. The machine may be tilted excessively to the front or rear; lengthen or shorten the top link to set the machine horizontally during work, ensuring the tractor PTO shaft end and machine input shaft are parallel. Alternatively, there might be insufficient machine side-to-side stabilization; use lower linkage arm stabilizers to address this.
What causes excessive wear on blades and blade holders of KUHN HRB202?
Excessive wear on blades and blade holders in KUHN Farm Equipment can be due to a couple of reasons. The PTO speed might be too high, so reduce it. Also, if the levelling bar is mounted at the rear, remove it if it is not required by the working conditions.
How to troubleshoot noisy drive when lifting KUHN HRB202 Farm Equipment?
A noisy drive when lifting KUHN Farm Equipment can be due to: a badly positioned or adjusted top link of the 3-point hitch. Position the top link parallel to the lower linkage arms to fix this. It can also be caused by excessive lifting height, so limit the lift linkage stroke.
What to do if KUHN HRB202 Packer roller is not functioning correctly?
If your KUHN Farm Equipment's Packer roller is experiencing issues such as clogging, jamming, or soil build-up, there are a few things to check. First, ensure that the scraper plates are correctly adjusted; adjust each scraper plate as needed. Also, if the scrapers are jammed by trash, clean them by pivoting them rearwards. Finally, make sure the scraper bar is correctly positioned. Scraper bars must always be in the furthest forward position, and wear compensation can only be obtained by sliding the scraper plates forward individually.
How to resolve Crumbler roller clogging on KUHN HRB202 Farm Equipment?
To resolve crumbler roller clogging on KUHN Farm Equipment, consider the following solutions. If wet conditions and a high load on the roller are the cause, remove the Crumbler roller removable bars. Alternatively, use a Packer PK2 roller or a Maxipacker roller.
What causes machine clogging in KUHN HRB202?
Machine clogging in KUHN Farm Equipment, specifically due to ground build-up between rotors and levelling bars, is often caused by a rear levelling bar mounted in wet conditions. Remove the rear levelling bar to resolve this issue.
What causes clogging of the Maxicrumbler roller in KUHN HRB202 Farm Equipment?
Clogging of the Maxicrumbler roller in KUHN Farm Equipment is caused by wet conditions and too high a load on the roller. To resolve this, use a Packer PK2 roller or Maxipacker roller.
General| Brand | KUHN |
|---|---|
| Model | HRB202 |
| Category | Farm Equipment |
| Language | English |
To Next Page
