EasyManua.ls Logo

KUHN HRB 122 - User Manual

KUHN HRB 122
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
KN135GGB F
OPERATOR'S MANUAL
Power harrows
HRB
122-152-182
KN135GGB F
- English - 11-2009

Questions and Answers

  • M
    Matthew TorresAug 7, 2025
    Why is my KUHN HRB 122 Farm Equipment requiring excessive power?
    • R
      Robert MccoyAug 7, 2025
      Excessive power requirement may be due to several factors. The working depth might be too deep, so reduce it using the roller. Alternatively, the rotor speed could be too high; try reducing the PTO speed. Also, check if your ground speed is too high and reduce it if necessary.
  • M
    Michael GarrisonAug 12, 2025
    What to do if the tilth produced by KUHN HRB 122 is too coarse?
    • A
      arthurmaciasAug 12, 2025
      If the tilth produced is too coarse, it might be due to a build-up of long plant residues around the blades; eliminate these residues. Also, check if your ground speed is too high and reduce it. If the rotor speed is too low, increase the PTO speed.
  • S
    serranostevenAug 16, 2025
    What to do if the tilth produced by KUHN HRB 122 Farm Equipment is too fine?
    • J
      Joshua GriffinAug 16, 2025
      If the tilth produced is too fine, it could be because the rotor speed is too high, so reduce the PTO speed. Another possible reason is that the forward speed is too slow, so increase forward speed.
  • D
    David ScottAug 20, 2025
    Why is my KUHN HRB 122 drive noisy during work?
    • M
      Marc WillisAug 20, 2025
      A noisy drive during work could be caused by the machine being tilted excessively to the front or rear. To fix this, lengthen or shorten the top link to set the machine horizontally during work, ensuring the tractor PTO shaft end and machine input shaft are parallel. Also, ensure sufficient machine side-to-side stabilization by using lower linkage arm stabilizers.
  • T
    tsimonAug 25, 2025
    How to fix noisy drive when lifting KUHN Farm Equipment?
    • C
      Cynthia MontgomeryAug 25, 2025
      A noisy drive when lifting the machine can occur if the top link of the 3-point hitch is badly positioned or adjusted; position the top link parallel to the lower linkage arms. It may also be due to excessive lifting height; limit the lift linkage stroke.
  • K
    kellymartinAug 28, 2025
    What causes excessive wear on blades and blade holders of KUHN HRB 122?
    • A
      agrahamAug 28, 2025
      Excessive wear on blades and blade holders may be due to a PTO speed that is too high. Reduce the PTO speed to mitigate this issue.
  • M
    michaelbryantSep 2, 2025
    What to do if the crumbler roller is clogging on my KUHN HRB 122?
    • A
      Angela EstesSep 2, 2025
      Crumbler roller clogging is often caused by wet conditions. In such conditions, remove the crumbler roller removable bars.

KUHN HRB 122 Specifications

General IconGeneral
BrandKUHN
ModelHRB 122
CategoryFarm Equipment
LanguageEnglish

Related product manuals