EasyManua.ls Logo

KUHN GMD 700 G II-HD - User Manual

KUHN GMD 700 G II-HD
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ASSEMBLY / OPERATOR'S MANUAL
GMD 600 G II / 700 G II / 800 G II
GMD 600 G II-HD / 700 G II-HD / 800 G II-HD
MULTIDISC MOWER
N° 95009 D.GB - 06.2006

Table of Contents

Questions and Answers

  • K
    kristingarciaAug 8, 2025
    Why is my KUHN GMD 700 G II-HD leaving uneven stubble?
    • T
      Thomas ShahAug 9, 2025
      Uneven stubble can occur for several reasons. It could be due to dull or broken knives, which require replacement. Ensure knives are installed correctly with the arrow on the upper face pointing in the disc's rotation direction. Check belts for correct tension if the disc speed is low. Increase engine speed to run the PTO at 540 rpm if the PTO speed is low. Finally, reduce tilt on the cutterbar if there is too much.
  • M
    Michelle HillAug 15, 2025
    What to do if soil builds up in front of the KUHN GMD 700 G II-HD Farm Equipment cutterbar?
    • B
      Brian MartinezAug 15, 2025
      Soil buildup in front of the cutterbar can be addressed by adjusting the compensating spring tension if there's too much cutterbar down pressure. If working in very wet conditions, adjust the main frame height by shortening the chain as needed. Consider fitting a set of raised skids.
  • C
    cookdonnaAug 21, 2025
    Why KUHN GMD 700 G II-HD cutterbar is not floating?
    • N
      nicholas27Aug 21, 2025
      If the cutterbar isn't floating, ensure the tractor spool valve is set to the float position, allowing the cylinder to move freely. Also, the compensating spring may need adjustment. Check the condition of the bevel gearbox mounting bushes and replace them if necessary, as wear or seizing can cause this issue.
  • T
    thompsonsheilaAug 27, 2025
    What to do if KUHN Farm Equipment stubble is too long?
    • J
      Jesse McneilAug 27, 2025
      If the stubble is too long, adjust the cutterbar angle using the tractor top link. You may also need to adjust the compensating spring tension and main frame height if there is insufficient cutterbar down pressure.
  • J
    Jennifer ThompsonSep 2, 2025
    Why is my KUHN GMD 700 G II-HD Farm Equipment machine breaking back too easily?
    • M
      Matthew BuchananSep 2, 2025
      If the machine is breaking back too easily, it could be due to insufficient tension on the breakaway spring washers; tighten them. Alternatively, reduce the tractor's ground speed if it's excessive for the field conditions.

Summary

Safety and General Information

Designated Use of the Machine

Specifies the intended use of the disc mowers and manufacturer's liability.

General Safety Recommendations

Outlines fundamental safety guidelines for operating the machine.

Operational Safety

Attachment Safety

Safety procedures for attaching the machine to the tractor.

Power Take-Off Safety

Safety precautions and procedures for operating the PTO shaft.

Hydraulic System Safety

Warnings and guidelines for safe use of the hydraulic system.

Maintenance and Inspection Safety

Maintenance Safety

Special Safety Recommendations

Specific safety advice for operating the mower.

Safety Decals

Explains the importance and location of safety decals on the machine.

Tractor Adaptation

Attachment of Lower Links and Positioning of Hitch Pins

Operational Procedures

P.T.O. Shaft

Instructions for connecting and ensuring correct PTO shaft length and angles.

Transport

Steps and safety warnings for transporting the machine on public highways.

Working Position

Mower Operation and Adjustments

Operating the Mower

Key operational guidelines and essential safety warnings for using the mower.

Adjustments - Cutting Height

Maintenance and Repair

Safety Break-Away

Parking the Machine

Inspection of Knives and Securing Elements

Component Replacement

Knife Replacement

Discs Replacement

Belts

Lubrication and Spring Adjustment

Adjustment of Compensating Spring Tension

Lubrication - Bevel Gearbox

Lubrication - Cutterbar

Troubleshooting and Storage

Trouble Shooting Guide

Lists common problems, their causes, and recommended remedies.

KUHN GMD 700 G II-HD Specifications

General IconGeneral
BrandKUHN
ModelGMD 700 G II-HD
CategoryFarm Equipment
LanguageEnglish

Related product manuals