How to fix noisy drive during work with KUHN Farm Equipment?
To resolve noisy drive issues during work with your KUHN Farm Equipment, ensure the machine is level by adjusting the top link so the tractor PTO shaft end and machine input shaft are parallel. Also, use lower linkage arm stabilizers to enhance side-to-side stabilization.
How to reduce excessive power requirement for KUHN HRB353D?
To decrease the excessive power requirement of your KUHN Farm Equipment, you can reduce the working depth using the roller, decrease the rotor speed by changing gearwheels in the gearbox (consider optional gearwheel sets), reduce ground speed, or raise/remove the rear leveling bar.
What to do if KUHN HRB353D Farm Equipment tilth produced is too coarse?
To correct a tilth that is too coarse when using KUHN Farm Equipment, eliminate plant residues, reduce ground speed, increase rotor speed by changing gearwheels in the gearbox (consider optional gearwheel sets), or install a leveling bar, preferably to the rear.
What to do if KUHN Farm Equipment packer roller is not functioning correctly?
To fix incorrect packer roller functioning on your KUHN Farm Equipment, adjust each scraper plate if they are incorrectly adjusted or worn out. If scrapers are jammed by trash, clean them by pivoting them rearwards. Ensure scraper bars are in the furthest forward position, adjusting scraper plates individually to compensate for wear.
What to do if KUHN HRB353D tilth produced is too fine?
To correct a tilth that is too fine when using KUHN Farm Equipment, reduce the rotor speed by changing gearwheels in the gearbox (consider optional gearwheel sets), increase forward speed, or raise or remove the rear leveling bar.
How to fix noisy drive when lifting KUHN Farm Equipment?
To address a noisy drive when lifting your KUHN Farm Equipment, position the top link parallel to the lower linkage arms and limit the lift linkage stroke to avoid excessive lifting height.
Why is my KUHN Farm Equipment clogging?
To prevent machine clogging due to ground build-up between rotors and leveling bars on your KUHN Farm Equipment, remove the rear leveling bar if you are working in wet conditions.
How to fix ridging at the side of KUHN HRB353D?
To correct ridging at the side of your KUHN Farm Equipment, position each anti-ridging plate as close as possible to the ground and roller on the side deflectors.
How to prevent excessive wear on KUHN HRB353D Farm Equipment blades?
To reduce excessive wear on blades and blade holders of your KUHN Farm Equipment, decrease the PTO speed and remove the rear leveling bar if it is not required by the working conditions.
General| Brand | KUHN |
|---|---|
| Model | HRB353D |
| Category | Farm Equipment |
| Language | English |
To Next Page
