Instructions for work
Power harrows
HRB353D - 403D
51
$Instructions for work
1. Putting the machine into work
position
From the transport position:
Lower machine until blades are at 100 - 150 mm (3.9’’ -
5.9’’) from the ground.
The machine is in working position.
2. Adjustments in working position
Working depth
The roller provides working depth adjustment and
control.
Fit the adjustment pin (2) in one of the adjusting plate
holes (1) to adapt the working depth.
Before placing the machine in working
position:
- Check that nobody is within the machine
pivoting area.
- If there is someone, make sure the
person moves away.
Adjust both sides to the same setting.
To Next Page
Loading...
