What to do if the table doesn't return to horizontal position on KUHN SW1604 Farm Equipment?
If the table doesn't return to the horizontal position after bale unloading on your KUHN Farm Equipment, check the table horizontal sensor position and inspect the sensor and its cable routing. Also, check for any obstructions blocking the wrapping table.
What does a voltage error mean on my KUHN Farm Equipment?
If you're getting a voltage error on your KUHN Farm Equipment, it might be due to low tractor battery voltage. Try switching off all heavy electric power consuming devices and restart the process. If the error persists, switch off all electric devices, turn off the engine, wait a moment, and then restart the engine before proceeding.
Why is the oil heating up in my KUHN Farm Equipment?
If the oil is heating up in your KUHN Farm Equipment, check the settings of the valve block and adjust if required. Also, reduce the hydraulic oil flow at the tractor.
What to do if the film is not retained after cutting on KUHN SW1604 Farm Equipment?
General| Bale weight | up to 1200 kg |
|---|---|
| Wrapping table | Yes |
| Film width | 750 mm |
| Transport Width | 2.50 m |
| Bale diameter | 1.6 m |
Manual for trained farmers/individuals; dealer provides training on operation and care.
Explains symbols and pictographs used in the manual for better comprehension.
Emphasizes following safety instructions for accident avoidance and machine safety.
Explains safety decals indicating dangers and their maintenance.
Defines who can operate/service the machine and general safety duties.
Safety precautions and procedures for hitching the machine to the tractor.
Safety for hydraulic couplings, pressure, and leak checks.
Installation of cable control lever unit and electronic connections.
Checking and setting hydraulic block for tractor system compatibility.
Complying with Road Traffic Act for safe transportation.
Steps to empty and position table/arm/wheels for transport.
Final check to ensure all conditions are met for road transport.
Safety rules and initial preparations before operating.
Adjusting table rollers, support rollers, and pre-stretcher.
Safety steps and procedures for loading film rolls.
Key safety points during machine operation.
Detailed steps for bale wrapping using cable or electronic control.
Overview of cable, electronic, and remote control systems.
Adjusting parameters for wrapping, counters, and system functions.
Safety rules and general cleaning steps for the machine.
Cleaning pre-stretcher rollers and post-cleaning lubrication.
Safety during storage and steps for unhitching the machine.
Tasks to perform when storing the machine long-term.
Safety, genuine parts, and general maintenance guidelines.
Tightening schedules and torque values for bolts.
Maintenance for pre-stretcher rollers and gears.
Maintenance for film cutter cylinder, knife, and sliding tube.
Safety, hoses, and oil filter maintenance.
Maintenance for drive chains.
Checks for axles, wheels, tyres, and bearings.
Cleaning and checking sensors.
Ordering parts, genuine accessories, and mounting guidelines.
Details on film break set, gear kits, remote control, etc.
Safety precautions before resolving problems.
Understanding error codes and continuing after resolution.
Common problems like film issues, loading arm, hydraulics.
Adjusting table lock, film cutter knife, sensors.
To Next Page
