10-10
MIDI Mode
The Channels Page
VolLock parameter to On, to ignore any MIDI volume messages the K2600 receives on a given
MIDI channel.
MIDIMode:CHANNELS||||||||||<>Channel:2||
Enable|:On||||||||||||||||||||||||||||||
Program:1|Concert|Piano|1||||PrgLock:Off
Pan||||:64|||||||||||||||||||PanLock:Off
Volume|:127||||||||||||||||||VolLock:Off
OutPair:Prog||||||||||||||||||||||||||||
OutGain:Prog||||||||||||||||||||||||||||
XMIT|||RECV|||CHANLS|PrgChg|RsetCh|Panic
Enable
Use this parameter to turn the currently selected channel on or off. When on, the channel will
receive MIDI information, and the settings of the parameters on the MIDI CHANNELS page
will be in effect. When off, the channel will ignore all MIDI information.
Program
Use this parameter to assign a program to the currently selected channel. The channel will still
respond to program change commands received via MIDI, unless the PrgLock parameter
(described below) is set to On.
Pan
This offsets the pan position of the current program as set on the OUTPUT page in the Program
Editor. A value of 0 is maximum offset to the left, 64 is no offset, and 127 is maximum offset to
the right. Changing the value of this parameter is like inserting a MIDI pan message. MIDI Pan
(MIDI 10) messages will change the value of this parameter, unless the PanLock parameter
(described below) is set to On.
If the Mode parameter on the OUTPUT page in the Program Editor is set to Fixed, changing the
value of Pan on the CHANNELS page in MIDI mode has no effect.
Parameter Range of Values Default
Enable Off, On On
Program Program list Program ID 1
Pan 0 to 127 64 (centered)
Volume 0 to 127 127 (maximum)
Output Pair Prog, KDFX-A to KDFX-D Prog
Output Gain Prog, –12 to 30 dB in 6 dB increments Prog
Program Lock Off, On Off
Pan Lock Off, On Off
Volume Lock Off, On Off
To Next Page
Loading...
Need help?
General
