MIDI Mode
The RECEIVE Page
10-5
The RECEIVE Page
Press
RECV
to select the RECEIVE page, where you deÞne the K2600Õs response to incoming
MIDI signals (with one exception pertaining to Quick Access mode, which weÕll explain later).
MIDIMode:RECEIVE||||||||||||||||||||||||
BasicChannel:
1||||||||
|SysExID:|||0|||||
MIDI|Mode|||:Multi|||||SCSI|ID:|||6|||||
AllNotesOff|:Normal||||BendSmooth:On||||
ProgChgType|:Extended||LocalKbdCh:None||
VelocityMap:|1|Linear||BankSelect:Ctl|32
Pressu
r
eMap:|
1
|Linea
r
||Powe
r
Mode|:
U
ser||
XMIT||
|
RECV||
|
CHANLS
|
PrgChg
|
RsetCh
|Panic
Basic Channel
The basic channel determines which channel will always be available to receive MIDI
information. Depending on the MIDI receive mode (below), the Basic channel may be the only
receiving channel, or one of several.
MIDI Receive Mode (MIDI Mode)
The MIDI Mode parameter determines the MIDI receiving capabilities of the K2600. When set to
Omni, the K2600 responds to incoming MIDI events on all MIDI channels, and plays them on
the current channel. This is normally used for diagnostic purposes only.
At a setting of Poly, the K2600 responds only to events that are sent on the same channel as the
K2600Õs current MIDI channel (the one displayed on the top line of the Program-mode page). In
Poly mode, the currently selected channel is always the basic channel, so if you change channels,
the basic channel changes accordingly.
With a value of Multi (the default), the K2600 responds to events on all active channels. This is
the mode youÕll use when youÕre driving the K2600 with a sequencer, since you can play a
different program on each channel. At this setting, you can turn individual channels on and off
(on the CHANNELS page, described later in this chapter).
Parameter Range of Values Default
Basic Channel 1 to 16 1
MIDI Mode Omni, Poly, Multi Multi
All Notes Off Normal, Ignore Normal
Program Change Type Program Change Type List Extended
Velocity Map Velocity Map list 1 Linear
Pressure Map Pressure Map list 1 Linear
System Exclusive ID 0 to 127 0
SCSI ID 0 to 7 6
Bend Smooth On, Off On
Local Keyboard Channel None, 1 to 16 None
Bank Select 0 only, 32 only, Ctl 0, Ctl 32 Ctl 32
Power Mode User, Demo User
To Next Page
Loading...
Need help?
General
