10-2
MIDI Mode
The TRANSMIT Page
Rack-model owners, keep in mind that only the Program Change Type, Program Change, and
Buttons parameters operate as programmed if the LocalKbdCh parameter on the RECEIVE page
does not match the transmit channel of your MIDI controller. If you set them to match, the
remaining parameters take effect as well.
Control Setup
This is where you select the current control setup, Zone 1 of which sets the physical controller
assignments for all programs while youÕre in Program mode. Refer to Chapters 6 and 7 for more
information on the control setup.
Note
: The control setup is responsible for many of the settings that each had separate parameters on the
K2000 and K2500. If youÕve worked with one of these instruments, youÕll need to relearn how MIDI
transmission controls are deÞned. Instead of setting a number of parameters on the MIDI TRANSMIT
page, youÕll simply select a control setup. Zone 1 of that setup then determines the controller assignments
(as speciÞed on the SLIDER, RIBBON, WHEEL, and other pages in the Setup Editor).
Channel
This deÞnes which MIDI channel the K2600 uses to transmit MIDI messages. The value for this
parameter matches the current MIDI channel displayed on the top line of the Program-mode
page. If you change the current MIDI channel while in Program mode, the setting of this
parameter changes accordingly, and vice versa.
Transpose
This parameter affects the transposition thatÕs applied to the MIDI data stream. Adjusting this
parameter transposes the K2600Õs notes, as well as notes on slaves receiving from the K2600.
This transposition setting is not overridden when you use Setup mode, but is
added
to the
transposition settings for the currently selected setup.
Control
Here you determine where the K2600 sends MIDI information. A value of
MIDI
sends the MIDI
signal to the K2600Õs MIDI Out port, but not to the K2600 itself. This is also known as Local
Control Off.
If youÕre using your K2600 with a MIDI sequencer and have a MIDI loop (K2600Õs Out to
sequencerÕs In, and vice versa), youÕll need to select a value of MIDI when your sequencerÕs
Parameter Range of Values Default
Control Setup Setup list 97 Control Setup
Channel 1 to 16 1
Transposition ±60 semitones 0
Control Both, MIDI, Local Both
Velocity Map Velocity Map list 1 Linear
Pressure Map Pressure Map list 1 Linear
Program Change Off, On On
Buttons Off, On Off
Change Setups Immed, KeyUp KeyUp
To Next Page
Loading...
Need help?
General
