10-18
MIDI Mode
The Soft Buttons in MIDI Mode
youÕve set the channel and the program change number, press the Send soft button to send the
program change command. Or press the Cancel soft button if you donÕt want to send it.
You can change the channel and the program number as many times as you want before you
press Send. You also can use the alphanumeric pad to select a program number directly.
Reset Channels (RsetCh)
When you press this soft button, the K2600 will ask you if you want to reset all channels, and a
pair of Yes/No soft buttons will appear. If you press the Yes soft button, all settings on the
CHANNELS page will return to their default values. For example, you may have set several
MIDI channels to route their audio to Output Group B for a special project. When the projectÕs
over, you can reset the Channels to restore the audio routing to each individual program (a
value of Prog), rather than selecting each channelÕs page and setting the Pair parameter back to
a value of Prog. Press the No soft button if you decide not to reset the channels.
Panic
This soft button sends an All Notes Off and All Controllers Off message both to the K2600 and
over all MIDI channels.
To Previous Page
Loading...
Need help?
General
