MIDI Mode
Program Change Formats
10-11
Volume
This sets the volume for any program assigned to the currently selected channel. A value of 0 is
silence, and a value of 127 is full volume. The value of this parameter will change in response to
MIDI Volume (MIDI 07) messages, unless the VolLock parameter (described below) is set to On.
Output Pair (OutPair)
This parameter sets the audio output group for the program assigned to the currently selected
channel. The default value of Prog means that the output group is determined by the programÕs
value for the Pair parameter on the OUTPUT page in the Program Editor. In this case, the
channelÕs output group changes depending on the program assigned to it, with the output
group being routed on a per layer basis within the program. Values of KDFX-A, KDFX-B,
KDFX-C, or KDFX-D Þx the output group regardless of the program thatÕs assigned to the
channel.
Output Gain (OutGain)
OutGain boosts or cuts the level at the audio outputs for any program assigned to the currently
selected channel. This allows you to make a program louder or softer without having to edit the
program.
Program Lock, Pan Lock, Volume Lock
When the parameter locks are set to On, the three parameters they control do not respond to
their respective MIDI controller messages. In that case, you could change the Program, Pan, and
Volume settings from the front panel, but not via MIDI.
Program Change Formats
The K2600 can store more programs than the MIDI program change speciÞcation can handle
(MIDI lets you send program change numbers from 0 to 127 or 1 to 128 only). So weÕve designed
a system that makes program selection more ßexible. This is true whether youÕre selecting
programs from the K2600Õs front panel, or via MIDI.
First of all, the K2600Õs programs (and all of its objects) are numbered and grouped according to
a decimal system, that is, in multiples of ten. This is much easier to keep track of than the binary-
oriented groupings of many synths, which feature banks of 8, 16, or 64 programs.
Program Change Type For Use With:
Extended Other K2600s (or K2500s or K2000s) similarly set, plus all other
instruments that use the Bank Change controller
Kurzweil K1200s, and 1000s with version 5 software
0–127 Older MIDI devices that transmit program change commands in the
range from 0–127 only.
QA Bank E Other K2600s (or K2500s or K2000s) similarly set, when in Quick
Access mode
QA Bank K K1200s and v5 1000s, when in Quick Access mode
QA 0–127 With the K2600 in Quick Access mode, when using it with older MIDI
devices
To Next Page
Loading...
Need help?
General
