Setup Mode
4-2
Sound Program For Each Zone
The bottom display row shows the Group and Program for each of the 3 zones. For example,
Zone 2 is using Group L and Program 9. A zone can also have no program assigned to it,
and the display shows “None”.
If you want to see the full name of a program that is assigned to a zone, simply press the
associated soft button (which then causes the display format to change). For example, if the
Zone 1 button (left soft button) is pressed, the display changes to:
Zone Muting
The bottom line displays the selected zone and its program name. Z1 stands for Zone1, Z2
for Zone2, and so forth. If the same zone soft button is pressed again, the zone will be
temporarily muted, that is, its sound will be turned off. Press the button a third time and
the sound returns. The zone soft buttons are lit when the corresponding zone sound is on.
It is best to experiment with this to understand exactly how it works.
The mute status is remembered until a different setup is selected. The mute status may also
be saved (see below).
If the same or a different setup button on the front panel is selected again, the display will go
back to the initial page.
Setup Edit Pages
There are a number of Setup Edit pages. The Setup Edit pages are where you will create or
modify setups to suit your performing needs. In addition to selecting programs, you can
adjust the volume, transposition, key range, effects levels, and other parameters for each of
the 3 zones. To edit the currently selected setup, press the Setup button. The Setup Mode
LED will begin flashing. The soft button LEDs continue to display the mute state of each
zone.
When you enter the edit pages, the default mute status of the setup will be reloaded. To exit
the Edit pages, press the Setup button again.
Factory Setups may be edited but the edited version must either be saved in a User Setup slot
or abandoned when a different setup is selected.
The Up and Down menu buttons at the left of the display can be used to select the desired
edit page. The page selection pins when either end of the list is reached. The pages (in
order) are:
1. Edit Sound Select
2. Edit Key Range Low, High
3. Edit Note Shift
4. Edit Vel. Range Low, High
5. Edit Volume
6. Edit Effect Type
FS01 Virtuoso Lead
Z1:K15 Sawyer’s Bomb
To Next Page
Loading...
