Master Mode
6-2
Managing Memory
These pages are used to manage the permanent memory which holds the various editable
parameters. Effects settings for Program Mode, User Setups, and MIDI/Master Parameters,
or all of these may be sent to a computer-based sequencer as a data string. Or they may be
received from a sequencer or the memory can be reset to its factory default state.
Sending Memory Data
The following page allows you to select what kind of data will be sent out. Use the + and -
buttons to scroll through the choices which are displayed on the bottom line. When the
desired data item is displayed, press the right soft button (“Send”) to continue.
The data item choices are:
All – All three of the data items listed below
Program FX – These are the effects settings for the 256 sound programs.
User Setups – These are the parameters of the 16 user setups.
MIDI/Master – These are the MIDI Mode and Master parameters.
After pressing Send, the following screen is displayed:
Pressing the left soft button will begin sending the memory data and proceed to the next
screen. The sequencer should be set up and recording before pressing Start. The right soft
button will cancel sending and return to the “Send memory data” page.
This screen will be displayed while the memory data is being sent out. The bottom line is
used to display a progress bar. When the send operation is complete, the “Send memory
data” page is displayed again.
Receiving Memory Data
This page allows you to receive previously sent memory data from a computer-based
sequencer. To begin the receive process, press the right soft button which will proceed to
Receive Memory Data
Receive
Sending Memory
To Next Page
Loading...
