9
Setting up the Instrument
Side Panel and Pedal Box assembly
We do not recommend attemting to assemble the MARK PRO ONE i alone.
The job can be easily accomplished, however, with only two people.
Use only the screws provided or replacement of exactly the specified size. Using
screws of the wrong size can result in damage to the instrument and personal injury.
1. Place the pedal box ④ on the side panel ③
and then use ⑧ screws to fasten the side
panel.
2. Place the Pedal Box ④ on the side panel ②
and then use ⑧ screws to fasten the side
panel.
3. You can find the pedal cable in the pedal box
④. Untie and straighten out the cable attached
to the bottom of the pedal box.
Rear Panel assembly
1. Fit into the holes ⑨ in the side panel
brackets and then use the screws ⑨ to fasten
the rear panel.
2. Use the screws ⑩ to fasten the bottom of the
rear panel.
⑨ ⑩
⑤
⑨
⑨
⑩
To Next Page
Loading...
