10
Setting up the Instrument
Attach the Keyboard
1. Place the keyboard on the stand so that the wood pegs on the bottom of the keyboard fit into the
holes in the side panel brackets.
2.
Fasten the keyboard to the side panel using screw number ⑦.
3. In
sert the pedal cable connector into the pedal jack located on the bottom of the keyboard.
4.
Rotate the pedal adjuster until it comes in firm contact with the floor surface. If the adjuster is not
in firm contact with the floor, the pedal will wobble and cause malfunctions.
5. In
stall the headphone hanger as shown in the figure.
Screws to faste n
the keyboard wi
th
side pan
el
c
a
j
e
l
b
a
c
l
a
d
e
P
k
e
n
o
h
p
d
a
e
H
s
a
j
c
k
Pedal adjuster
Be sure that the connector is inserted in the correct orientation.
Make sure that the cable clamp fastens to the pedal cable.
To Next Page
Loading...
