Maintenance and Upgrades
Boot Block
A-5
Resetting the PC1
If you select by scrolling and pressing Enter, the display will ask
which gives you an important opportunity to think about what you are doing. This
resets all of the PC1’s memory back to the initial factory state. This is necessary if you are
upgrading the software. If you’re not concerned about losing all of your work, or it has been
saved using a MIDI Sysex dump (see page 4-7), then press the button beneath the Yes on the
display. The PC1 will execute a hard reset and start running normally.
Running the Diagnostics
The option executes the diagnostics that are loaded with the operating system.
Some diagnostic tests will erase the PC1’s memory, which will cause a hard reset when the PC1 is
powered on again. Power off and power on your PC1 to leave diagnostics and return to normal
operation.
To Next Page
Loading...
