Kurzweil PC2R - Page 138

B-6
General Reference
Parameter Reference
Setups: Velocity
Vel Scale -300 to 300% 100%
Vel Offset -127 to 127 0
Vel Curve Linear, Sin+, Cos+ Linear
Vel Min 1–127 1
Max 1–127 127
Setups:
Continuous
controllers
These
controllers all
have the same
six parameters,
called the Basic
Parameter
Group.
Default values
are usually the
same, with the
exception of Ctrl
Num; its value
varies for each
controller
Wheel 1 Up
Ctrl Num
Ctrl Scale
Ctrl Offset
Ctrl Curve
Entry Value
Exit Value
Any control source or destination (Next column for defaults)
-300 to 300% (default 100%)
-127 to 127 (default 0 for all)
Linear, Sin+, Cos+ (default Linear)
None, 0–127 (default None)
None, 0–127 (default None)
Wheel 1 Up Ctrl Num:
Pitch Up
Wheel 1 Down
Wheel 1 Down
Ctrl Num: Pitch Down
Red Knob B
Red Knob B Ctrl
Num: Mod Whl
MPressure
MPressure Ctrl Num:
Pressure
Green Knob A
Green Knob B
Green Knob C
Green Knob D
Pedal 1
Red Knob C
Red Knob D
Setups:
Continuous
controllers:
Ribbons
Ribbons have
three common
parameters,
called the
Spring
Parameter
Subgroup
The ribbon
controllers also
have the six
basic
parameters.
Ribbon Sect Large, 3 Sect. Large
Spring
Parameters
Spring Switch Off, On On
Ribbon Mode Absolute, Relative Relative
Spring Pos 0–127 64
Ribbon 1 basic
parameters
As indicated in Basic Parameter Group
Ribbon 2 spring
parameters
As indicated in Spring Parameter Subgroup
Ribbon 2 basic
parameters
As indicated in Basic Parameter Group
Ribbon 3 spring
parameters
As indicated in Spring Parameter Subgroup
Ribbon 3 Basic
parameters
As indicated in Basic Parameter Group
Setups: Switch
controllers
All switch
controllers have
the same seven
parameters,
called the
Switch Control
Parameter
Group
Amber Swch A
SwType
On Ctrl
On Value
Off Ctrl
Off Value
Entry State
Exit State
Momentary, Toggle (default Momentary)
Any control source or destination (default None)
None; 0–127 (default None)
Any control source or destination (default None)
None; 0–127 (default None)
None, Off, On (default None)
None, Off, On (default None)
Amber Swch B
Amber Swch C
Amber Swch D
Red Switch A
SwitchPdl 1
SwitchPdl 2
SwitchPdl 3
Menu
Subgroup
(if any)
Parameter Range of Values Default