3
-
2
Disassembly/Assembly
Opening the PC3x
Opening the PC3x
PC3x Bottom
Refer to Figure 3-1. Arrows indicate the locations of the enclosure support wall, endcap and rear
panel screws.
Figure 3-1 PC3x bottom enclosure
Caution: Do not remove the endcap or rear panel screws at this point of the procedure.
1. Tilt the PC3x up and remove the four enclosure support wall screws.
2. Place the unit flat on your work surface.
3. Move the unit so that the rear panel portion of the unit hangs over the edge of your work
surface. This gives you access to the eight screws that secure the rear panel portion of the
top enclosure to the bottom enclosure. Remove the eight screws.
Note: Two of these screws also secure the rear panel portion of the access panel. It is not
necessary to remove the five remaining access panel screws.
4. Slide the unit back onto the work surface.
Rear panel screws
Keyboard
Endcap screws
*
Endcap screws
*
*Endcap locking bracket screws
Access panel
Enclosure support wall screws
Rear panel
To Next Page
Loading...
