Internal Voices Mode
Modifying Other Internal Voice Parameters
3-5
MIDI Channel
1-16 and Off
SpeciÞes which MIDI channel to send on. No MIDI signals are sent if the value is Off.
Destination
Int, Mid, Bot
This speciÞes where your performance data should be sent. Int means the internal
sound module, Mid means MIDI, and Bot means both.
Internal Effect
0-9, Noc
This is the effect number for the currently-selected sound. A value of 0 means no
effect, and Noc (no change) means the effect doesnÕt change when this sound is
selected. As you select different sounds, the value of this parameter will change.
Transpose
-60 to 60
Subtracts or adds the speciÞed number of semitones to the notes you play. Caution:
changing this parameter while keys are down may cause stuck notes.
Velocity Curve
1-8
Allows you to alter the relationship between keyboard playing effort (keystroke
velocity) and the resulting sound volume (for velocity sensitive voices). 1 is normal.
See page 4-11, and Velocity Curve on page 4-6 for more.
Reverb Wet/Dry, Chorus Wet/Dry
0-100, Noc
This is the effect intensity for the currently-selected sound. Noc means that the effect
intensity doesnÕt change when this sound is selected.
A Ribbon
0-129, Off
SpeciÞes where signals from the left ribbon are sent. See the Info Strip for
corresponding MIDI controller names. Default is Pitch Wheel, which the internal
sound module does not respond to.
Hold or Center
Hld, Ctr
SpeciÞes whether the A ribbon signal remains at its last value or returns to center
when your Þnger is lifted. Default is Center (Ctr).
B Ribbon Up, B Ribbon Down
0-129 and Off
SpeciÞes where signals from the two halves of the right ribbon are sent. Defaults are
Modulation Wheel (01) and Pan (10) respectively. Some sounds will respond to
modulation but none will respond to Expression.
To Next Page
Loading...
