8-4
Reference
Factory Default MIDI Setups
Factory Default MIDI Setups
The 32 factory-default MIDI Setups are all the same except for the Internal Sound
parameter which is set to be the same as the setup number. MIDI parameter settings
are also similar to the Internal Voices Setup. In particular, only the Left Zone is
enabled. In fact, until you edit the MIDI setups to meet your particular needs, there
will be little difference between Internal Voices mode and MIDI Setups mode.
MIDI Setup Parameters
The following table lists the parameters and default values for MIDI Setup 1. The
other MIDI setups have identical values, except for the Internal Sound parameter.
Values for Key Range Lo and Key Range Hi are given for the SP88. For the SP76, these
values are 28Ð103. (E 1ÐG 7).
Noc stands for No Change, which means that a parameter retains its value when you
select another MIDI setup.
Parameter
(Column 1)
Default Value
Parameter
(Column 2)
Default Value
Left Right Left Right
Internal Sound
Grand Piano 1 Reverb Wet/Dry Noc Noc
MIDI Program Off Off Chorus Wet/Dry Noc Noc
MIDI Bank Sel Lo Off Off A Ribbon 128 128
MIDI Bank Sel Hi Off Off Hold or Center Ctr Ctr
MIDI Channel 1 Off B Ribbon Up 1 1
Destination Bot MIDI Hold or Zero Zer Zer
Internal Effect Noc Noc
B Ribbon Down 10 10
Hold or Zero Zer Zer
Key Range Lo 21 (A 0) 21 Control Slider 7 7
Key Range Hi 108 (C 8) 108 Control Pedal 4 4
Transpose 0 0 Switch Pedal R 64 64
Velocity Curve 1 1 Switch Pedal L 66 66
To Next Page
Loading...
