4-10
MIDI Setups Mode
Switch Controller Destinations
84 84 Portamento Control When Portamento Switch (65) is turned on and
Portamento Time (5) is not zero, the value of this
Controller is the MIDI note number from which
the pitch glide will start.
85–90 Undefined
91 Reverb Depth Controls the mix ratio of reverberated sound to
unprocessed sound (0 = all unprocessed,
127=all reverberation). The Stage Piano’s
internal sound module responds to this control.
92 Effects 2 Depth General effects control.
93 Chorus Depth Controls the mix ratio of chorus processed
sound to unprocessed sound. The Stage Piano’s
internal sound module responds to this control.
94 Effects 4 Depth General effects control.
95 Effects 5 Depth General effects control.
96 Data Increment Used in conjunction with Registered and Non-
Registered Parameter Numbers (98-101) to
decrement (lower the value of a particular
parameter. Not all synthesizers respond to this.
97 Data Decrement Same as 96 but increment edits the parameter.
98 Non Reg Parm LSB This and 99 address a manufacturer-and model-
specific parameter to be edited. Not all
synthesizers respond to this.
99 Non Reg Parm MSB See 98.
100 Registered Parm LSB This and 101 address a standardized parameter
to be edited.
101 Registered Parm MSB See 100.
102–119 Undefined Function varies freely with the receiving device.
118 is the Stereo/Mono switch for the internal
sound module. 119 is the Tune control for the
internal sound module (64=A440).
120–127 Channel Mode Set These set the MIDI mode of the receiving device
and generally should not be used as control
destinations.
128 Send as Pitch Bend The value is sent as a Pitch Bend (or Pitch
wheel) message. Default destination of
A Ribbon.
129 Send as Pressure The value is sent as a Channel Pressure
message. It allows some other control to
assume the function of key pressure (or
Aftertouch) which the Stage Piano’s keyboard
lacks.
MIDI # Controller Name Description
Table 4-2 Switch Controller Destinations (Continued)
To Next Page
Loading...
