To Next PageTo Next Page
Need help?Do you have a question about the Kvaser Leaf Light v2 and is the answer not in the manual?
Introduces the Kvaser Leaf Light v2 as a reliable, low-cost product for CAN communication.
Details key features like USB CAN interface, compatibility, and high-speed connection.
Information on Kvaser CANlib SDK, software development, and where to download documentation.
Guide for installing the Kvaser driver and connecting the device to a host computer.
Instructions and location for updating the device's firmware.
Specifies that the device uses a standard USB type “A” connector.
Describes the single CAN Hi-Speed channel and various connector types available.
States that the Kvaser Leaf Light v2 is powered via the USB port.
Details the function of the Power (PWR) and CAN LEDs.
Guidance on diagnosing communication problems using Kvaser Device Guide and checking LEDs.
Provides detailed technical specifications for the Kvaser Leaf Light v2.
Details the pinout for the 9-pin D-SUB and 16-pin OBDII CAN connectors.
Explains the necessity of 120 Ohm termination resistors for CAN bus operation.
Details critical safety warnings regarding the device's use in distributed embedded systems.
Presents the EU Declaration of Conformity for the Kvaser Leaf Light HS v2.
Lists trademarks, patents, and copyright information related to the product and software.
General| Number of Channels | 1 |
|---|---|
| Galvanic Isolation | No |
| Operating Temperature | -40°C to +85°C |
| Supported CAN Standards | CAN 2.0A and 2.0B |
| Interface | USB 2.0 |
| CAN Standard | ISO 11898-2 |
| Bit Rate | Up to 1 Mbit/s |
| Weight | 100 g |
| Connector | 9-pin D-SUB |
| Timestamp Resolution | 100 µs |
| Power Supply | USB |
| Operating Voltage | 5 V |
