Kvaser U100 - Technical data

Kvaser U100 User’s Guide 12 (22)
4.4 Technical data
In Table 6 on Page 12 below you will find the Kvaser U100’s technical
specifications.
CAN Channels 1
CAN Transceivers ADM3055E (Compliant with ISO 11898-2)
CAN Controller Built into the processor.
Galvanic isolation Yes, reinforced. Design validated with 5000 VAC rms applied for 60 s.
CAN Bit Rate 10 kbit/s to 1 Mbit/s
CAN FD Bit Rate Up to 8 Mbit/s (with correct physical layer implementation).
Time stamp resolution 100 µs
Max message rate 20 000 msg/s per channel
Error Frame Detection Yes
Error Frame Generation No
Silent mode No
Kvaser MagiSync No
PC interface USB 2.0
Power consumption Typical 250 mA
Hardware configuration Done by software (Plug & Play)
Software requirements Windows (7 or later), Linux
Dimensions 38 x 128 x 26 mm for body
Cable length USB 1.0 m, CAN 0.3 m
Weight 167 g with default connectors
Operating temperature −40
◦
C to +85
◦
C
Storage temperature −40
◦
C to +85
◦
C
Relative humidity 0 % to 85 % (non-condensing)
IP Rating IP67
Table 6: Technical Specifications
Kvaser AB, Mölndal, Sweden — www.kvaser.com