© 2016 Spectrum Brands, Inc.
2.4 Configuration Parameter 37
Parameter Name: Audio Feature Control
Data Length: 1 byte
Default Value: 1 – enabled
Possible Values: 1 – enabled, 0 – disabled
Description:
The configuration parameter 37 is a one byte field that will allow the user to get / set the
value for the Audio feature. The value of 0 means that the setting is disabled; whereas
the value of 1 means that the setting is enabled.
Sending a set command with the default field set to 1 will cause the control to revert back
to its factory default setting.
2.5 Configuration Parameter 40
Parameter Name: Reset Lock to Factory Default
Data Length: 1 byte
Default Value: 0
Possible Values: 1 – have lock perform factory reset
Description:
The configuration parameter 40 is a one byte field, used to set the lock to its default
setting, known as a factory reset command.
Reading this parameter will always return a value of 0.
Writing a value of 1 to this parameter will cause both the lock and Z-Wave card to reset
back to their default settings and will remove itself from the network. All network
information, including associations will be cleared.
2.6 Configuration Parameter 47
Parameter Name: Motor Load Control
Data Length: 1 byte
Default Value: 0
Possible Values: 1 – enabled, 0 – disabled
Description:
The configuration parameter 47 uses 1 byte that will allow the user to get / set the value
to enable or disable the motor load alarm. Setting this byte to 0 will disable the alarm,
whereas setting this byte to 1 will enable the alarm. If a motor load alarm has been
activated and the alarm has been enabled, the alarm will be sent via the Power
Management group in the Notification Command Class as a Load Error (0x09).
To Next Page
Loading...
Need help?
General
