ENGINE OIL (MXU 150)
1.Engine oil level measurement
A. Place the machine on a level place.
B. Warm up the engine for several minutes
and stop it.
C. Remove the dipstick (1) and wipe it off with
a clean rag. Insert the dipstick in the filler
hole without screwing it in.
D. Remove the dipstick and inspect the oil
level.
E. The oil level should be between the
maximum (2) and minimum marks (3). If the
level is low, add oil to raise it to the proper
level.
Wait a few minutes until the oil level settles
before checking.
Be sure no foreign material enters the
crankcase.
NOTE:
CAUTION:
(1) Dipstick/oil filler cap
(3) Minimum level mark
(2) Maximum level mark
(1)
(2)
(1)
(3)
130
To Next Page
Loading...
