Kymeta u8 - Page 24

© 2020 Kymeta Corporation. All rights reserved. 24 08 December 2020
700-00121-000 revD Kymeta u8 products installation and user guide
If you utilize the antenna reset button, and depress the button for 5 seconds or longer, the u8 reverts to baseline
network configuration:
Network Interface Network Setting Baseline configuration (after reset)
Local network IP Mode static
Local network IP Address 192.168.0.10
Local network Netmask 255.255.255.0
Local network Gateway blank/empty
Local network DNS Server blank/empty
Admin VLAN IP Mode static
Admin VLAN IP Address 192.168.45.2
Admin VLAN Netmask 255.255.255.0
Admin VLAN Gateway blank/empty
Admin VLAN DNS Server blank/empty
Data VLAN IP Mode dhcp
Data VLAN IP Address 10.12.12.2
Data VLAN Netmask 255.255.255.0
Data VLAN Gateway 10.12.12.3
Data VLAN DNS Server 8.8.8.8
If you utilize the antenna reset button, be sure to replace the network configuration as defined by the tables above.
Utilize the Kymeta web-based UI at Settings > Network to adjust the values to match the as-shipped configuration or
as required. It is recommended to utilize the Admin Wired Ethernet Port to access and make corrections to reduce
connectivity issues