Kyocera DuraPro - Call from Contacts; Call Using a Speed Dial Number

Phone Calls & Settings 21
Note: You cannot make calls from History to entries identified as No Caller ID, Private
(Restricted ID), or Unavailable ID.
Call from Contacts
Place a call to the numbers stored in your Contacts.
1. From standby mode, press CONTACTS (right softkey).
2. Highlight the entry you want to call.
3. Press to dial the entry’s default phone number.
– or –
To dial another number from the same entry, press to select the entry, highlight a
number, and then press .
Call Using the Plus (+) Code
When placing international calls, use Plus Code Dialing to automatically enter the
international access code for your location (for example, 011 for international calls made
from the U.S.).
1. Press and hold to display “+” on your phone screen.
2. Enter the country code and phone number, and then press . (The phone
automatically prepends the access code for international dialing, followed by the
country code and phone number.)
Call Using a Speed Dial Number
You can store up to 98 numbers in your phone’s speed dial memory to make contacting
friends and family easier.
You must have already assigned a speed dial number to an existing phone number. See Assign
Speed Dial Numbers.
To use speed dial for locations 2-9:
►
From standby mode, press and hold the appropriate key for approximately two seconds.
To use speed dial for locations 10-99:
►
From standby mode, enter a two-digit speed dial number, and then press .
The display confirms that the number has been dialed when it shows “
Connecting...
”