8-114
Default Setting (System Menu)
3
Press the
or
key to select [Service Setting].
4
Press the
OK
key. Service Setting appears.
5
Press the
or
key to select [Service Status] or
[Network Status].
6
Press the
OK
key. A confirmation screen appears.
The screen shown is the one when Network Status is
selected.
7
Press [Yes] (the
Left Select
key). The selected report is
output.
Accepted.
is displayed and the screen returns to
the Service Setting menu.
NOTE:
When acceptance of jobs is prohibited,
Print, storing functions are restricted now.
is displayed and the
output is canceled.
Send Result Report
Automatically print a report of transmission result when a transmission is complete. The table below shows the
available settings. The default setting is
Error Only
.
Use the procedure below to send a Result Report.
1
In the Sys. Menu/Count. menu, press the
or
key to
select [Report].
Item Description
Off No result report printed.
On Result report automatically printed.
Transmitted images can also be attached.
Error Only Result report printed only when a
transmission ends in an error. If two or
more destinations are registered, the
reports are printed only for the destinations
with the errors. Transmitted images can
also be attached.
To Next Page
Loading...
