Kyocera ECOSYS M2035dn

8
8-163
Default Setting (System Menu)
5 Press the  or  key to select [Secure Protocol].
6 Press the OK key. Secure Protocol appears.
7 Press the  or  key to select [POP3 Security 1],
[POP3 Security 2] or [POP3 Security 3].
If you selected POP3 Security 1, follow the procedure
below. If you selected POP3 Security 2 or POP3 Security
3, set in the same way.
8 Press the OK key. POP3 Security 1 appears.
9 Press the  or  key to select [Off], [SSL/TLS] or
[STARTTLS].
10 Press the OK key. Completed. is displayed and the
screen returns to the Secure Protocol menu.
SNMPv3 Setting
Sets up SNMPv3. The default setting is Off . Use the procedure below.
Refer to
Protocol Detail on page 8-151 about the procedures.
Secure Protocol: a b
4 LDAP Security
5 SMTP Security
*********************
[ Exit ]
6 POP3 Security 1
POP3 Security 1: a b
*********************
2 SSL/TLS
3 STARTTLS
1 *Off