Kyocera ECOSYS M3145dn - Page 277

8-17
Setup and Registration (System Menu) > System Menu
Ping
Restart Network
Optional Network
[System Menu/Counter] key > [▲] [▼] key > [System/Network] > [OK] key > [▲] [▼] key > [Optional Network] >
[OK] key
Configure settings for the optional Network Interface Kit.
Basic
Item Description
Ping Checks if communication with the destination by entering the host name or IP address of the
destination is possible.
NOTE
If [Primary Network] is set to [Option Network], this item is not displayed.
Item Description
Restart Network Restarts the network.
NOTE
This menu is displayed when the optional Network Interface Kit or Wireless Network Interface Kit is installed.
Item Description
Host Name Check the host name of the machine. Host name can be changed from Command Center RX.
Changing Device Information (page 2-48)
TCP/IP Settings For details on setting value.
TCP/IP Settings (page 8-11)
IPSec (page 8-12)
Bonjour Select whether to use Bonjour.
Value: Off, On
Wi-Fi Direct
*1
*1 Displayed only when the wireless network function is available on the machine.
Set whether to enable this function for each network.
Value: Disable, Enable
Wi-Fi
*1
Wired Network
IPSec Select whether to use IPSec.
Value: Off, On
LAN Interface Select the LAN Interface type.
*2
NOTE
Value: Auto, 10Base-Half, 10Base-Full, 100Base-Half, 100Base-Full, 1000Base-T
This function is displayed when the optional Network Interface Kit is installed.
*2 The setting will be changed after restarting the device or network.
MACAddressFilter Select whether to use MAC Address Filter.
Operation Guide for the optional Network Interface Kit
Value: Off, On
Restart Network Restarts the network card of the device.