Troubleshooting
OPERATION GUIDE 4-13
Print overrun
Press GO
The data transferred to the printer was too complex to print on a page. Press
[GO] to resume printing. (The page may break in some pages.)
You can abandon printing by [CANCEL].
NOTE: After this message is displayed, page protect mode will be On. To
maintain optimum use of memory during printing, display >Page
Protect from
the operation panel, and re-select Auto.
If Auto Continue is set to On, printing will be automatically resumed after a preset
period of time.
RAM disk error ##
Press GO
Look at the error code given in place of ## and refer to the corresponding
description given below.
01: Format error. Try turning the power off and on again.
02: RAM disk mode is Off. Turn RAM disk mode On.
04: No disk space. Clean up files.
05: Specified file is not on disk.
06: No memory for use by disk system. Expand printer memory.
Virtual mailbox
full
The storage area for the VMB is full. Print out accumulated VMB data.
USB mem. removed
Press GO
The USB flash memory is accidentally removed from the printer. To ignore the
USB memory error, press [GO]. The message display returns to Ready.
USB memory err05
Press GO
The designated file does not exist. Check the designated file name and existence
of the file in the USB memory.
:Alarm buzzer sounds when an error occurs. Press [CANCEL] to stop the alarm buzzer.
Message Corrective Action
;Ò
;Ò
;Ò
;Ò
To Next Page
Loading...
Need help?
General
Weight and Dimensions
