Accounting System Settings Guide
Chapter 2 Setting Up the Accounting System
5
Chapter 2 Setting Up the Accounting System
This chapter describes the accounting system menus and how to set them up.
There are two ways to set up the accounting system.
• Enter settings through the printer operator panel
• Enter settings by inputting the PRESCRIBE commands
Most functions and commands operate the same way on all models. However, some
functions and commands are not relevant to certain specific models.
Administration IDs
An administration ID is required to control the accounting system.
An administration ID is a 15-digit number. The default setting is the printer model
number followed by a string of zeros (e.g., 602000000000000 for the FS-6020).
The administration ID can be changed to any number. (Refer to Change
Administration ID on page 11.)
Write down the administration ID and keep it in a safe place so that you do not forget
it.
To Next Page
Loading...
Need help?
General