8
2-2 Entering Settings through the Printer Operator Panel
This section describes how to enter accounting system settings through the printer
operator panel. Basic operations are the same as those for the printer mode menu.
Set Account Management
ON/OFF
Turns Account Management ON/OFF. At least 1 Account must exist before turning ON.
1 Make sure Ready is displayed on the operator panel.
2Press [MENU] while holding down [ENTER]. AdministrationID
appears on the operator panel.
3 Press [] or []. 0 appears at the far left position and the cursor blinks.
4 Press [ ] or [ ] to enter a number (0 through 9).
5 Press [ ]. The number is entered and the cursor auto moves to the next right
position. Repeat step 4 and this step at each position to enter all 15 digits of the
administration ID.
6Press [ENTER]. Account Management Off appears on the operator panel..
Ready
AdministrationID
AdministrationID
0
AdministrationID
6
AdministrationID
602000000000000
Account >
Management Off
To Next Page
Loading...
Need help?
General