Using the Operator Panel
2-38 ADVANCED OPERATION GUIDE
3
Press [OK] ([ENTER]). A blinking question
mark (?) appears.
4
Select KPDL or KPDL (AUTO) using U or
V.
5
Press [OK] ([ENTER]).
6
Press Z. Press U or V until >Print KPDL
Errs (errors) appears.
7
Press [OK] ([ENTER]). A blinking question mark (?) appears.
8
Select On using U or V. Press [OK]
([ENTER]).
9
Press [MENU]. The display returns to Ready.
Default Font
You can select the default font for the current interface. The default font
can be one of the internal fonts or a font that is downloaded to the printer
memory or stored on memory card or hard disk.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
1
Press [MENU].
2
Press U or V repeatedly until Font >
appears.
3
Press Z. Press U or V until >Font
Select > appears.
4
To select an internal font, make sure that
Internal is displayed and press Z. The
display changes. If Internal is not
displayed, press [OK] ([ENTER]), then
press U or V until it appears.
Emulation
?PCL 6
Emulation
?KPDL
>Print KPDL Errs
Off
>Print KPDL Errs
? Off
Font >
>Font Select >
Internal
>> I000
To Next Page
Loading...
Need help?
General
