2-4 Printing Operation
TCP/IP (IPv6)
This section describes how to enable the TCP/IP (IPv6) protocol.
1 If TCP/IP (IPv6) is set to Off, use U or V to selecto On and press
[OK].
2 Press Z. Each time you press U or V, the selection changes.
3 Display the item you want to set and press [OK]. A blinking question
mark (?) appears while you are setting RA(Stateless) and
DHCPv6.
4 Press U or V to select On or Off as the setting for RA(Stateless)
and DHCPv6.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
NetWare, AppleTalk, IPP, SSL Server, IPSec and Security
Level settings
1 Press [MENU].
2 Press U or V repeatedly until Security > appears.
Note Check with your network administrator for the network
address settings.
To Next Page
Loading...
Need help?
General