Kyocera KM-NET - FRPO Parameter Setting

Operation Guide
49
Broadcast
The Broadcast dialog box appears.
2 Browse the command file or enter the command in the Broadcast text box. The
maximum length of command is 256 characters.
3 Click Send to send the command to the printing system.
9.2. FRPO Parameter Setting
Perform the following procedure to change the FRPO parameter.
1 Click Broadcast to open the broadcast dialog box. The Broadcast dialog box
appears.
2 Enter the parameter (for example R4) in FRPO.
3 Click Get. The current value is shown in Value.
4 Erase the current value and enter the new value. For example, to change the
default paper source to the MP Tray in the above example, enter 0 instead of 1 in
Value.
5 Click Set. The value is changed.