MA2000w & PA2000w Setup Quick Guide 8
Before setting up printer you first must,
download the Mac Driver from Kyocera.info
and run the installer. This will install all
software required.
1. Open a browser on your computer and
type in Kyocera.info.
2. Enter your model # and click the model
when it shows.
USB Setup for MAC
Step 1
3. Scroll down the page and download
the Mac Driver and install it on your
computer.
4. Press and hold [Main Power] (●) for 2
seconds or more to turn the power ON.
5. Connect the USB cable to the printer’s
USB interface connector.
Note: Use a USB cable with a rectangular
Type A plug and a square Type B plug.
The USB cable should be shielded and no
longer than 5 meters (16 feet) long.
To Next Page
Loading...
