Basic Operation
3-9
3
Density
Use this procedure to adjust the density when copying.
You can adjust density using 7 or 13 levels.
The procedure for adjusting the density of copies is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Set the original on the platen and press [Color/
Image Quality] -> [Density].
4 Adjust density pressing [-3] (Lighter) to [+3]
(Darker). You can change the density level [-3]
(Lighter) to [+3] (Darker) in half-steps.
5 Press [OK].
6 Press the Start key. Copying begins.
To Next Page
Loading...
