INTRODUCTION
The Align Reverb was built from the ground up to
complement the natural body dynamics and warmth
of acoustic instruments that we love so much. The
circuit seamlessly integrates the wet and dry signals
with the eect in side chain so that it never overwhelms
the original signal. We shaped the reverb with analog
EQ to reect the natural voice inherent in acoustic
instruments. Additionally, the tone control adds versa-
tility by sweeping from warm and muted to open and
present. The result is an organic reverb that maintains
the audiophile purity of the original signal with the
controls set in any position.
GETTING STARTED
1. Power the Reverb with a 9V power supply or a 9V
battery.
2. Plug your guitar into the input to activate the
Reverb (upper right hand side) and a cable into the
¼” output (upper left hand side).
3. Start with the volume control at noon. This should
match the engaged signal with the bypassed signal.
4. Plug the ¼” cable into your amp, PA, or next pedal in
the signal chain and experiment with the Reverb
.
To Next Page
Loading...
Need help?
General
