L3 Communications FA2100 - Table of Contents

COMPONENT MAINTENANCE MANUAL
AVIATION RECORDERS
FA2100CVR
Dec. 09/13
Table of Contents
23–70–04
Rev. 13 Page xxxv
TABLE OF CONTENTS
SUBJECT/DESCRIPTION Page
INTRODUCTION
1. GENERAL 1...................................................................
2. ACRONYMS AND ABBREVIATIONS 1...........................................
3. DOCUMENT REQUIREMENTS 2................................................
4. RECORDER DEFINITIONS 2....................................................
5. MAINTENANCE PHILOSOPHY 3................................................
6. COMPONENT MAINTENANCE MANUAL (CMM) DESCRIPTION 3...................
A. FRONT MATTER 3........................................................
B. DESCRIPTION AND OPERATION 3.........................................
C. TESTING AND TROUBLESHOOTING 4......................................
D. DISASSEMBLY 4..........................................................
E. CLEANING 4..............................................................
F. CHECK 4.................................................................
G. REPAIR 4.................................................................
H. ASSEMBLY 5.............................................................
I. SPECIAL TOOLS AND TEST FIXTURES 5...................................
J. ILLUSTRATED PARTS LIST 5..............................................
7. DOCUMENT VERIFICATION 5..................................................
8. COMPONENT MAINTENANCE MANUAL (CMM) EFFECTIVITY 6...................
9. PART NUMBER FORMATTING 6................................................
DESCRIPTION AND OPERATION
1. GENERAL 1...................................................................
2. FA2100 CONFIGURATIONS 2...................................................
3. SYSTEM DESCRIPTION 2......................................................
A. Underwater Acoustic Beacon 3..............................................
B. Circuit Boards 3...........................................................
C. Power, Control and Monitor Signal Interface Characteristics 3...................
(1) Stop Recording Command 6............................................
(2) Control Unit Operating Power and Monitor Audio Signals 6.................
(3) Control Unit Test and Bulk Erase Signals 8...............................
D. Voice Data Interface Characteristics 9........................................
E. Data Recording Storage 10.................................................
(1) Output Audio Quality 12................................................
(2) GMT/FSK Output Signals 13............................................