4 | Page
ALARM CLOCK READINGS
WHAT IS THIS EXTRA SENSOR AREA?
Explanation: The Extra Sensor area is a place to show up to 4 additional, compatible,
sensors on the alarm clock itself. These sensors may also be scanned to your La Crosse View
App.
So, if you want extra Temperature/Humidity sensors, you can display them here.
If you do not have or want additional sensors, this area will show you the 30 NAP.
Optional Extra Sensors:
Up to 4 additional Thermo-Hygro, Wind Speed, Rain, Water Leak or
any combination of these sensors can read to the EXTRA SENSOR area of your display.
Simply press and release the EXTRA SENSOR button to view these sensors.
Purchase Extra Sensors:
For additional sensors to read to your alarm clock or to the app visit
the
PARTS TAB
at: http://bit.ly/C82929
Note:
Not all sensors will read to the alarm clock. Be sure to check the chart to see if a
sensor can read to the app only, or both alarm clock and app.
HOW DO I ADD EXTRA SENSORS TO MY ALARM CLOCK?
1.
Hold the EXTRA SENSOR button 3 seconds, to add a sensor to the alarm clock.
2.
Install batteries in the sensor, and if the sensor has a TX button, press the TX button to
force a
signal.
3.
Allow up to 3 minutes to view sensor and ID on alarm clock.
Note:
Once sensor is found the search will stop. Sensor, ID, and type will show for 3
seconds then return to normal display.
4.
Scan sensor bar code ID so it will read in the La Crosse View app.
5.
Added sensors will be available for display in Extra Sensor area of alarm clock.
HOW DO I DELETE EXTRA SENSORS FROM MY ALARM CLOCK?
1. Press and release the EXTRA SENSOR button until you see the sensor and ID you wish to
delete.
To Next Page
Loading...
Need help?
General
