65
To wall mount:
1. Secure the bracket onto a desired wall using the screws and
plastic anchors.
2. Clip the sensor onto the bracket.
Note:
Before permanently fixing the transmitter wall base, place all units
in the desired locations to check that the outdoor temperature and
humidity readings are receivable. In event that the signal is not
received, relocate the transmitter(s) or move them slightly as this
may help the signal reception.
The mounting surface can, however, affect the transmission range. If for example the
unit is attached to a piece of metal, it may then either reduce or increase the
transmitting range. For this reason, we recommend not placing the unit on any metal
surfaces or in any position where a large metal or highly polished surface is in the
immediate proximity (garage doors, double-glazing, etc.). Before securing in place,
To Next Page
Loading...
