44
3. The Projection clock will now start receiving the DCF time signal. After
approximately 3 to 5 minutes, the DCF time will be displayed (Also see "SETTING
UP" below) .
Important!
Use only the adapter provided with the projection
clock and make sure that your household voltage
is appropriate to the working voltage of the
transformer. Otherwise your Projection clock may
be damaged.
POWER SUPPLIED BY BATTERIES AND AC/DC ADAPTER
If the Projection clock is first powered by batteries and the power adapter is
subsequently used for extended period of time, the main power source of the Projection
clock will switch to AC/DC power. The batteries will then act as a backup power source
in case of power failure.
To Next Page
Loading...
