WS6282 User Manuals
19. Operation button
20. DC input jack
21. Battery compartment cover
22. Bracket
Initial operation:
Open the main unit battery compartment cover
Insert 2 x AAA batteries observing polarity [ “+” and “ –“ marks]
When you insert the batteries, all icons on the LCD will light up for 3 seconds, and you will
hear a beep tone, then detect indoor temperature & humidity.
The main unit will now start to make a connection to the outdoor remote sensor. This process
lasts for a maximum of 3 minutes and will displayed by a flashing reception antenna symbol
In the upper right corner of the number of channels.
This moment, Open the remote Sensor battery compartment cover, push the channel switch
to select the number of channels to use, Insert 2 x AAA batteries according to the correct
polarity 【Reference “+” and “–” marks】, Press the “℃/°F” button to select the temperature
unit you want, close the battery cover.
After receiver has created a connection to the outdoor remote sensor, after up to 3 minutes it
will enter the DCF Radio control time receive mode (The backlight will turn off during RC
reception).
The backlight will remain on after DCF reception is completed.
Reception of the Radio signal:
Press and hold the【 】 button to manually enter the DCF radio control receiving function,
when the adapter is used for power supply, the backlight will be automatically and
temporarily turned off after entering receiving mode. After receiving, it will automatically
return to the previous backlight brightness.
Enters DCF receiving mode, the symbol will flashing, when a valid signal is detected
the symbol no flashing and switch to is flashing, after about a few minutes, the
receiving process will end.
：Received successfully
：The previous reception was successful, but the last reception failed
At 1:00 /2:00 / 3:00 AM, the clock automatically carries out the synchronization procedure
with the DCF signal to correct any deviations to the exact time. If this synchronization
attempt is unsuccessful, the system will automatically attempt another synchronization at
the next full one hour. This procedure is repeated automatically up to total 5 times.
To Next Page
Loading...
Need help?
General
