flashing
1. Use the MIN/MAX/+ key to select the “12h” or “24h” display mode.
2. Press the SET to confirm and to enter the Time zone setting mode.
Note: When 24h mode display is selected, the calendar format will be "Weekday.
Day. Month" display. When 12h mode display is selected, the calendar format
will be "Weekday. Month. Day" display.
TIME ZONE SETTING
The time zone can be set between ±12 hours (default 0 hour):
1. The time zone starts flashing.
2. Use the MIN/MAX/+ key to change the time zone. The range runs from 0, -1, -
2…-12, 12, 11, 10… 2, 1, 0, in consecutive 1-hour intervals.
3. Press the SET key to confirm and enter the Time reception ON/OFF setting
mode.
TIME RECEPTION ON/OFF SETTING
In area where reception of the radio-controlled time (DCF time) is not possible, the
time reception function can be turned OFF. The clock will then work as a normal
Quartz clock. (Default setting is ON).
Time zone (flashing)
To Next Page
Loading...
Need help?
General
